IBM WebSphere DataPower 7198, Инструкция по установке и эксплуатации

Страница: 48 / 88

After defining the base firmware configuration, the screen displays information
that is similar to the following information. The screen shows information
specific to your appliance.
Welcome to DataPower XI52 console configuration.
Copyright IBM Corporation 1999-2011
Version: XI52.4.0.2.0 build 123456 on 2011/06/13 12:32:13
Serial number: 68A00000
You must read and agree to the terms of the license agreement using the
WebGUI. If you did not configure the Web Management Interface, you must do
it now with the web-mgmt command.
xi52#
The previous sample shows the following information:
v
The appliance is a DataPower XI52 appliance.
v
The firmware version running on the appliance is
4.0.2.0
at the
123456
build level.
v
The current time on the appliance is 12:32:13 on June 13, 2011.
v
The serial number for the appliance is of
68A00000
.
v You must configure the Web Management Interface with the web-mgmt
command.
Next step:
Create additional administrators who can reset passwords. See
“Procedure 3 of 4: Creating users who can reset passwords.”
Procedure 3 of 4: Creating users who can reset passwords
To reset the password for the
admin
account if the password is lost, you need a
user with privileged access or a user in a group with the
*/*/*?Access=rwadx
access policy.
Before you begin: Initial the appliance by changing the password for the admin
account and interactively defining the base configuration. See “Procedure 2 of 4:
Initializing the appliance” on page 27.
The following command sequence illustrates the creation of the
adminTwo
privileged.
# configure terminal
(config)# user adminTwo
New User configuration
(config user adminTwo)# password
Enter new password: ********
Re-enter new password: ********
(config user adminTwo)# access-level privileged
(config user adminTwo)# summary ID for privileged backup user
(config user adminTwo)# exit
(config)# write memory
Overwrite previously saved configuration? [y/n]: y
(config)# exit
#
For complete information about creating privileged users or creating user groups
with the
*/*/*?Access=rwadx
access policy, see the administrative topics in the
information center about creating users and creating user groups.
28
Installation and User's Guide