IBM Types 2193, Руководство по техническому обслуживанию аппаратной части, Страница: 90 / 198

78
IDE connector. (Please refer to the connectors and
functions illustrated in chapter 5.)
q
IDE Secondary Channel Master and Slave Drives in
BIOS Setup should be connected to the system board
secondary IDE connector. (Please refer to the
connectors and functions illustrated in chapter 5.)
NOTE: The CD-ROM drive that comes with system unit
should be configured as IDE Secondary
Channel Master device.
q
Check the hard disk and CD-ROM drives jumper
settings. See “3.5-In. Hard Disk Drive Jumper Locations”
on page 141 and "CD-ROM Drive" on page 83.
q
Check the voltages of all disk drive power connectors.
See “Power Supply Cable Connector Specifications” on
page 137.
q
Correct the parameter settings under Disk Drives in the
BIOS Setup. See ”IDE Drives Setup” on page 45.
q
In the BIOS Setup, check that the correct drive size is
set for the flagged drive shown in the Installed Devices
list.
q
Load default settings.
q
If the problem remains, check the continuity on the drive
and the cable and replace it if necessary. If that does not
fix the problem, replace the system board.
q
End.
005 –
q
Select Diagnostics from the PC-Doctor diagnostics
program main menu. Select and execute Floppy Disk
Test if you want to test the diskette drive. Select and
execute Hard Disk Test if you want to test the hard disk
drive.
q
Select Interactive Tests from the PC-Doctor diagnostics
program main menu, then select and execute CD-
ROM/DVD Test if you want to test the CD-ROM drive.
q
If the diagnostics program did not detect a failure, but
the system still displays a failure:
q
If an error or other symptom appears, go to “Index of
Symptoms, Messages, Error Codes, or Beeps” on page
59.
q
If no error can be detected or the symptom is
intermittent, go to “Undetermined Problems” on page 93.
q
End.