IBM TURBOWAYS 622 PCI MMF ATM, Инструкция по установке и использованию

Страница: 9 / 44

Chapter 1. Overview
The TURBOWAYS 622 PCI MMF ATM Adapter is a 64–bit, universal PCI adapter that
provides direct access to ATM networks through a dedicated 622 Mbps full-duplex
connection. It is a PCI short form factor adapter and connects to the 622 ATM network
through an LED-driven, dual-SC type, multimode fiber optics cable. The 622 PCI MMF
Adapter uses 16 MB of SDRAM (synchronous dynamic random access memory) for
control and 16 MB of SDRAM for packet memory.
The TURBOWAYS 622 PCI MMF ATM Adapter provides the following features:
v
33 Mhz and 66 Mhz operation
v
Full-duplex operation
v
SVC (switched virtual circuit) and PVC (permanent virtual circuit) support
v
16 MB of control memory and 16 MB of packet memory
v
Fiber SC connector for multimode fiber cabling
Note: Instructions assume you are connecting the TURBOWAYS 622 PCI MMF ATM
Adapter on AIX to an ATM switch or concentrator. If you have any problems
installing or configuring your adapter, refer to “Appendix C. Troubleshooting” on
page 31 for problem-solving information.
Software Requirements
The TURBOWAYS 622 PCI MMF ATM Adapter is supported on AIX Version 4.3.3 or
later. The device driver for AIX 4.3.3 is shipped with the adapter and included in the
″
AIX 4.3.3 Additional Device Software
″
CD. If support is required on an earlier version
of AIX release, ensure that this adapter is supported on that release prior to installation.
Contact your support representative for assistance.
1