IBM Turbo 16/4 Token-Ring PC Card 2, Руководство пользователя

Страница: 102 / 123

Recommended Actions Table
Table 8. Recommended Actions
Number Description
1 After delaying at least 30 seconds, retry the open two times,
inserting the same delay between each try.
2 After delaying at least 30 seconds, check the PC Card configuration
(especially the PC Card data rate) and retry the open.
2a If this error persists, contact your network administrator for
assistance and provide Open Error information.
2b If this error persists, contact your network administrator for
assistance.
3 Contact your network administrator for assistance and provide Open
Error information.
4 Contact your network administrator for assistance and provide Node
Address information, and try attaching to the ring after 6 minutes.
5 If this error persists, problem determination of the PC Card or lobe is
necessary. Contact your network administrator for problem
determination assistance.
Transmit Error Codes
If you experience time-out errors during the on-ring test, try running the wrap test in
the diagnostics. If the wrap test is completed successfully, but the on-ring test fails,
it might indicate problems on the Token-Ring network that the adapter is opening
onto during the on-ring test.
For any other errors, ensure that the adapter and cabling are properly connected,
and retry the test. If the adapter continues to fail, record the error and contact your
network administrator.
01 Unrecognized command code
08 Unauthorized access priority
22 Error on frame transmission, examine STRIPPED_FS
23 Error on frame transmit or strip process
24 Unauthorized MAC frame
25 Maximum commands exceeded
26 Correlator not acceptable
27 Link not transmitting I frames, status changed from link open
28 Transmit frame length not acceptable
29 Link retransmission in process, buffers free
40 Station ID not acceptable
41 Protocol error, link not in acceptable state for command
86
Turbo 16/4 Token-Ring PC Card 2