IBM totalstorage fastt100, Инструкция по установке, эксплуатации и обслуживанию, Страница: 58 / 160

3. If the latch does not automatically lock when you have successfully inserted the
fan unit into the bay, pull back slightly on the fan and then push it in again until
the latch snaps into place.
4. Repeat step 1 through step 3 to replace the second fan.
Replacing a hard disk drive
Complete the following steps to replace the hot-swap hard disk drives that you
removed before the installation.
Note: Use Table 17 on page 103 to verify the proper replacement locations of your
FAStT 1.5 Gbps SATA hard disk drives.
1. Lift up on the handle and gently push the drive CRU into the empty bay until the
hinge of the tray handle latches beneath the storage server bezel.
2. Push the tray handle down until the latch clicks into place.
3. Repeat step 1 and step 2 to replace additional drives.
Setting the interface options
The FAStT100 has two server ID switches that identify the FAStT100 on a
fibre-channel loop and that assign physical addresses to the drives. The server ID
switches are located on the back of the storage server, as shown in Figure 20 on
page 29.
Tray handle
f10ug055
Figure 19. Removing a drive CRU
28
IBM TotalStorage FAStT100 Storage Server: Installation, User’s, and Maintenance Guide