IBM TotalStorage DS4200, Инструкция по установке, использованию и обслуживанию

Страница: 73 / 222

5. Connect an LC-LC fibre-channel cable. For information about the LC-LC cable,
see “Using LC-LC fibre-channel cables” on page 48.
Removing SFP modules
Complete the following steps to remove the SFP module from the host port:
Attention: To avoid damage to the cable or to the SFP module, make sure that
you unplug the LC-LC fibre-channel cable before you remove the SFP module.
1. Remove the LC-LC fibre-channel cable from the SFP module. For more
information, see “Removing an LC-LC fibre-channel cable” on page 50.
2. Unlock the SFP module latch:
v
For SFP modules that contain plastic tabs, unlock the SFP module latch by
pulling the plastic tab outward 10°, as shown in Figure 25.
v For SFP modules that contain wire tabs, unlock the SFP module latch by
pulling the wire latch outward 90°, as shown in Figure 26 on page 48.
Protective cap
Plastic tab
SFP module
Figure 24. Installing an SFP module into the host port
10
o
SFP module
Protective cap
Plastic tab
Figure 25. Unlocking the SFP module latch - plastic variety
Chapter 3. Cabling the storage subsystem
47