IBM TotalStorage DS4200, Инструкция по установке, использованию и обслуживанию

Страница: 139 / 222

3. Determine the bay into which you want to install the EV-DDM.
4. Remove the blank tray by completing the following steps:
a. Release the latch on the drive CRU by pressing on the inside of the bottom
of the tray handle.
b. Lift the closed latch to its open position. (The latch is at a 90° angle to the
front of the drive when open.)
c. Pull the blank tray out of the bay.
d. Save the blank tray for later use.
5. Install the EV-DDM by completing the following steps:
Note: The EV-DDM comes installed in a drive tray. Do not attempt to detach
the EV-DDM from the tray.
a. Release the latch on the EV-DDM CRU by pressing on the inside of the
bottom of the tray handle.
b. Pull the handle on the tray out so that it is in the open position, as shown in
Figure 74.
Tray handle
Tray latch
e
xp80012
c. Slide the EV-DDM CRU into the empty bay until the hinge of the tray handle
latches beneath the storage subsystem bezel or the adjacent drive CRU
bezel.
Figure 73. Hot-swap hard disk drive LEDs
Figure 74. EV-DDM CRU handle
Chapter 5. Replacing components
113