IBM TotalStorage 2109 M12, Инструкция по установке и обслуживанию

Страница: 97 / 159

7. From the serial console for the healthy (and active) CP card, back up the
current configuration for logical switch 0. See the possible output from the
configupload command in step 8.
a. Run the configupload command.
b. Enter the requested information at the prompts.
8. Log into logical switch 1 and back up the current configuration for switch 1.
a. From the serial console for the healthy CP card, enter the login command.
b. Log into the switch as
Admin
and enter
1
to log into Switch 1.
c. Enter the configupload command.
d. Enter the requested information at the prompts.
See the following example for possible output.
SW0:admin> configupload
Server Name or IP Address [host]: 123.456.78.90
User Name [None]: user
File Name [config.txt]: config.txt
Password: xxxxxx
upload complete
SW0:admin>
SW0:admin> login
cp0 login: admin
Password: xxxxxx
Enter Switch Number to Login <0 or 1>: 1
SW1:admin>
SW1:admin> configupload
Server Name or IP Address [host]: 123.456.78.90
User Name [None]: user
File Name [config.txt]: config.txt
Password: xxxxxx
upload complete
SW1:admin>
Removing a CP card or filler panel
Attention: Wear an ESD grounding strap when handling a CP card. The chassis
has a grounding connection above the power connectors.
Attention: Hold the CP card by the edges of the metal pan (not by the ejectors).
Note: To allow the current configuration to be copied to the new CP card, you must
install a new CP card while the other CP card is still operating.
Perform the following steps to remove a CP card:
1. Ensure that the other CP card is healthy and functioning as the active CP. See
“Confirming a failed CP card” on page 65 for more information. Run the
haShow command to determine which is the active CP card.
2. If the card that you are replacing is the standby CP card, continue with step 3. If
the card that is being replaced is the active CP card, verify that the standby CP
card is healthy. The power LED should be green, and the status LED should not
be lit. Run the haFailover command to make the standby CP card act as the
new active CP card.
3. Remove the CP card that you are replacing.
a. Disconnect the following cables if they are present:
Chapter 6. Servicing the M12
67