IBM TotalStorage 2109 M12, Инструкция по установке и обслуживанию

Страница: 38 / 159

You can modify the configuration only through a login session to the active CP card.
The switch supports up to two Telnet sessions with administrative privileges at the
same time.
The same administrative login account applies to both logical switches. If the
password is changed on switch 0, it automatically changes on switch 1.
The M12 configuration includes the following parameters:
v
General system parameters
You can modified these parameters with the configure command. For more
information, see the Brocade Fabric OS Reference .
v
WWNs for both logical switches
You cannot modify the two WWNs. Both of them are preconfigured and are
usually based on the chassis-serial number.
v
Domain ID
The default domain ID for both logical switches is 1. You can modify it by using
the configure command.
v
One domain ID for any of the 16–port cards in slots 1–4 and one for any of the
16–port cards in slots 7–10
You can modify domain IDs with the configure command.
v Native IP addresses
A native IP address, host name, subnetmask, and gateway address for both CP
card slots. You can modify it by using the ipAddrSet command.
v Logical IP addresses
A logical IP address and subnetmask for both logical switches. You can modify it
by using the ipAddrSet command.
Note: If you reset a logical IP address while the switch has active IP traffic, you
can cause the IP traffic to be interrupted or stopped. IP traffic might
include Web Tools, Fabric Watch, SNMP, and other applications.
Items required
You will need the following items to configure and connect the M12:
v
An M12 that is powered on and is not connected to a network or fabric
v A workstation computer with a terminal emulator application, such as
HyperTerminal
v
The serial cable that is provided with the switch
v
Two Ethernet cables
v
SFP transceivers and cables, as required
v
Two IP addresses for the native IP addresses that are assigned to the CP slots,
with the corresponding native host names, subnetmasks, and gateway
addresses. The default native IP addresses and host names are as follows:
– 10.77.77.75 CP0 (the CP card in slot 5 at the time of configuration)
–
10.77.77.74 CP1
(the CP card in slot 6 at the time of configuration)
v Two IP addresses for the logical IP addresses of the switch, with the
corresponding subnetmasks. These IP addresses correspond to “switch 0”, which
contains any 16–port cards in slots 1–4, and “switch 1”, which contains any
16–port cards in slots 7–10. The default logical IP addresses are as follows:
–
10.77.77.77 sw0
–
10.77.77.76 sw1
8
IBM TotalStorage SAN Switch: 2109 Model M12 Installation and Service Guide