ii
DANGER
Do not remove the covers under any circumstances.
Do not connect the equipment to, or disconnect the
equipment from, a mains power outlet during an
electrical storm.
DANGER
To avoid shock hazard:
• The power cord must be connected to a properly
wired and earthed socket.
• Any equipment to which this product will be
attached must also be connected to properly wired
sockets.
Power Cords
For your safety, IBM provides a power cord with a grounded attachment
plug to use with this IBM product. To avoid electrical shock, always use
the power cord and plug with a properly grounded outlet.
IBM power cords used in the United States and Canada are listed by the
Underwriters Laboratories (UL) and certified by the Canadian Standards
Association (CSA).
For units intended to be operated at 115 volts: Use a UL listed and CSA
certified cord set consisting of a minimum 18 AWG, type SVT or SJT,
three conductor cord, a maximum of 4.57 metres (15 feet) in length and
a parallel blade, grounding type attachment plug rated 15 amperes, 125
volts.
For units intended to be operated at 230 volts (U.S. use): Use a UL
listed and CSA certified cord set consisting of a minimum 18 AWG, type
SVT or SJT, three conductor cord, a maximum of 4.57 metres (15 feet)
in length and a tandem blade, grounding type attachment plug rated 15
amperes 250 volts.
For units intended to be operated at 230 volts (outside the U.S.): Use a
cord set with a grounding type attachment plug rated 13 amperes
(minimum), 250 volts. The cord set should be marked <HAR> and have
the appropriate safety approvals for the country in which the equipment
will be installed.
Important: To isolate the monitor from the electrical supply you must
remove the plug from the mains power socket. The monitor should be
situated as close to the mains socket as possible, allowing easy access.
legal.doc Page ii Wednesday, July 12, 1995 5:16 PM