IBM ThinkPad 130, Руководство по введению

Страница: 27 / 104

Multiple Load Module
The network operator can transfer and save either one or two CCU load modules
(up to 6MB per load module) on the integrated hard disk. Either load module can
be selected for loading at controller initialization.
When initiating a control program load request at the host, the network operator
can designate the disk-resident load module that will be
active for later automatic
control program loading and dump.
| The network operator can change the external name of a communication controller
| load module on the MOSS disk. The rename load module function is started by a
| modified VTAM command (load command).
A control program load request that is initiated automatically by MOSS uses the
load module last loaded in the CCU if it was saved to the disk or loaded from the
disk during IPL. This load module is displayed specified as the
active load module
at the 3745 console (see “Disk IPL Information” on page 4-32).
Remote Loading and Activation
For a remote 3745 connected to a channel-attached 3745 via a switched subarea
link (NTRI, X.21 switched or X.25 leased and switched), the remote loading and
activation capability allows the host (through VTAM commands) to load and start
the remote NCP:
Ÿ From the remote disk to the remote CCU storage.
As the loading of the NCP load module on the remote 3745 hard disk is done via a
1MB diskette written from the local 3745 hard disk, this option is used when the
NCP load module size does not exceed 1MB. (See “MOSS Functions” on
page 4-27 for local disk to diskette and remote diskette to disk NCP transfer):
Chapter 3. Program Support and Network Management
3-3