IBM T541H, Инструкция по установке и эксплуатации

Страница: 8 / 12

2. Press both sides of the back panel
1
and push it outward from the monitor to
remove it completely. Push panel
2
upward to remove.
®
3.
Push the remaining panel outward from the monitor to remove.
4. To replace the back panels, reverse the steps, after bezel speaker cabling has
been routed and attached (see step 6 on page 5).
Attaching your flat panel speaker bezel to your monitor
Follow these instructions to connect your speakers to your flat panel monitor, refer
to the illustration for identification.
1
DC power cable (from bezel speaker assembly)
2
DC power plug
3
DC power receptable (not required for T541H)
Attention:
Do not attach a power adapter to this repetacle while attached to the T541H.
1. Locate the cables on your flat panel monitor speaker bezel. The dc power
cable
1
is hardwired to your speaker bezel.
2.
Remove the back panels on the IBM T541H monitor. See “Removing the back
panels from your T541H flat panel speaker” on page 3.
3. Connect the dc power plug
2
to the receptacle connector on the monitor.
4
Speaker Bezel: Flyer