IBM System x3755 M3 7164, Инструкция по установке и эксплуатации

Страница: 55 / 126

Removing the top cover
Note: Before you install optional hardware devices, make sure that the server is
working correctly. Start the server, and make sure that the operating system starts,
if an operating system is installed, or that a 19990305 error code is displayed,
indicating that an operating system was not found but the server is otherwise
working correctly. If the server is not working correctly, see the
Problem
Determination and Service Guide on the IBM Documentation CD for information
about how to run diagnostics.
Important: The server automatically powers off when the top cover is removed.
To remove the top cover, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 28.
2. Turn off the server and all attached peripheral devices. Disconnect all power
cords; then, disconnect all external signal cables from the server.
3. Slide the server out of the rack until the slide rails lock into place.
4. Loosen the two thumbscrews that secure the cover to the chassis.
Thumbscrew
Cover
5. Press on the two blue grip points and slide the cover toward the rear; then, lift
the cover off the server. Set the cover aside.
Removing the top-cover fan door
Attention: You must turn off the server before you remove or install a
non-hot-swap fan.
To remove the top-cover fan door, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 28.
2. If you are removing or replacing a non-hot-swap fan, turn off the server and all
attached peripheral devices. Disconnect all power cords; then, disconnect all
external signal cables from the server.
3. Slide the server out of the rack until the slide rails lock into place.
4. Press and rotate up the release latches.
Chapter 2. Installing optional devices
37