IBM System x3690 X5, Руководство по обслуживанию, Страница: 56 / 464

Clearing the error logs
To clear the event logs, complete the following steps.
Note: The POST event log is automatically cleared each time the server is
restarted.
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. If you have set both a
power-on password and an administrator password, you must type the
administrator password to view the event logs.
3. Use one of the following procedures:
v
To clear the IMM system-event log, select
System Event Logs --> System
Event Log
. Select
Clear System Event Log
; then, press Enter twice.
POST
When you turn on the server, it performs a series of tests to check the operation of
the server components and some optional devices in the server. This series of tests
is called the power-on self-test, or POST.
Note: This server does not use beep codes for server status.
If a power-on password is set, you must type the password and press Enter (when
you are prompted), for POST to run.
If POST detects a problem an error message is displayed. See “POST error codes”
for more information.
If POST detects a problem, an error message is sent to the POST event log.
POST error codes
The following table describes the POST error codes and suggested actions to
correct the detected problems. These errors can appear as severe, warning, or
informational.
38
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide