IBM System x3550 M3, Инструкция по установке и эксплуатации

Страница: 111 / 160

Installing the optional two-port Ethernet adapter
To install the Ethernet adapter, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 44.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the cover” on page 52).
4. Remove the PCI riser-card assembly (if installed) from PCI riser connector 1
(see “Replacing a PCI riser-card assembly” on page 68).
5. Attach the rubber stopper on the chassis, along the edge of the system board,
as shown in the following illustration.
Rubber
stopper
Ethernet
adapter connector
Rubber
stopper
6. Remove the adapter filler panel on the rear of the chassis (if it has not been
removed already).
7. Install the two standoffs on the system board.
8. Insert the bottom tabs of the metal clip into the port openings from outside the
chassis.
Chapter 2. Installing optional devices
95