IBM System x3250 M4, Инструкция по установке и эксплуатации

Страница: 71 / 108

Select this choice to view or change the server component settings.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0
compliant adapters and drivers installed in the server.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports. You can configure the serial ports, configure remote console
redirection, enable or disable integrated Ethernet controllers. If you disable a
device, it cannot be configured, and the operating system will not be able to
detect it (this is equivalent to disconnecting the device).
– Power
Select this choice to set the Power Restore Policy when power loss occur.
The other two options is for
Active Energy Manager and Power Restore
Policy . When in the Power Restore Policy option, you can choose from three
modes
- Always on: System will remain ON once power is restored.
- Restore: Restore system to the same state it was on before power loss
occur.
- Always off: System will remain OFF once power is restored.
– Operating Modes
Select this choice to choose from four options:
- Efficiency: Highest performance per watt.
- Acoustic: Lower acoustic level and lowest power.
- Performance: Highest performance.
- Custom: Customized settings.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is
Disable .
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
Chapter 3. Configuring the server
53