IBM System x3100 M4, Инструкция по установке и эксплуатации

Страница: 40 / 108

Installation guidelines
Before you install options, read the following information:
v Read the safety information that begins on page vii, the guidelines in “Working
inside the server with the power on” on page 23, and “Handling static-sensitive
devices” on page 23. This information will help you work safely..
v
When you install your new server, take the opportunity to download and apply
the most recent firmware updates. This step will help to ensure that any known
issues are addressed and that your server is ready to function at maximum levels
of performance. To download firmware updates for your server, complete the
following steps:
1. Go to http://www.ibm.com/supportportal/ or http://www.ibm.com/support/
fixcentral/.
2. Under Product support , click System x .
3. Under Popular links , click Software and device drivers .
4. Click System x3100 M4 to display the matrix of downloadable files for the
server.
v
Before you install optional hardware, make sure that the server is working
correctly. Start the server, and make sure that the operating system starts, if an
operating system is installed. If the server is not working correctly, see the
Problem Determination and Service Guide for diagnostic information.
v Observe good housekeeping in the area where you are working. Place removed
covers and other parts in a safe place.
v If you must start the server while the cover is removed, make sure that no one is
near the server and that no tools or other objects have been left inside the
server.
v Do not attempt to lift an object that you think is too heavy for you. If you have to
lift a heavy object, observe the following precautions:
– Make sure that you can stand safely without slipping.
– Distribute the weight of the object equally between your feet.
– Use a slow lifting force. Never move suddenly or twist when you lift a heavy
object.
– To avoid straining the muscles in your back, lift by standing or by pushing up
with your leg muscles.
v Make sure that you have an adequate number of properly grounded electrical
outlets for the server, monitor, and other devices.
Note: When attaching a monitor to the equipment, you must use the designated
monitor cable and any interference suppression devices supplied with the
monitor.
v Back up all important data before you make changes to disk drives.
v
Have a small flat-blade screwdriver, a small Phillips screwdriver, and a T8 torx
screwdriver available.
v Blue on a component indicates touch points, where you can grip the component
to remove it from or install it in the server, open or close a latch, and so on.
v When you have to access the inside of the server, you might find it easier to lay
the server on its side.
v When you are finished working on the server, reinstall all safety shields, guards,
labels, and ground wires.
v For a list of supported options for the server, see http://www.ibm.com/systems/
info/x86servers/serverproven/compat/us/.
22
System x3100 M4 Type 2582: Installation and User's Guide