IBM System x3100 M3, Инструкция по установке и эксплуатации

Страница: 48 / 94

Installing drives
Depending on the server model, a DVD-ROM or multiburner drive might be installed
in the server. The server supports up to four 3.5-inch simple-swap SATA hard disk
drives.
The following illustration shows the locations of the drive bays.
Bay 1
Bay 2
Bay 3
Bay 4
Bay 5
Bay 6
Bay 7
The following notes describe the types of drives that the server supports and other
information that you must consider when installing a drive:
v Make sure that you have all the cables and other equipment that is specified in
the documentation that comes with the drive.
v
Select the bay in which you want to install the drive.
v Check the instructions that come with the drive to see whether you have to set
any switches or jumpers on the drive. If you are installing a SATA device, be sure
to set the SATA ID for that device.
v
Optional internal or external USB diskette drives, tape drives, DVD-ROM, and
multiburner drives are examples of removable-media drives. You can install
removable-media drives in bays 1, 2, and 3 only.
v
The SATA removable-media drives that you install in bay 1 connects to the SATA
5 connector on the system board and the drive in bay 2 connects to the SATA 4
connector on the system board.
v To install a 3.5-inch drive in a 5.25-inch bay, you must use the 5.25-inch
conversion kit.
v
The electromagnetic interference (EMI) integrity and cooling of the server are
protected by having all bays and PCI and PCI Express slots covered or
occupied. When you install a drive, PCI, or PCI Express adapter, save the EMC
shield and filler panel from the bay or PCI or PCI Express adapter slot cover in
the event that you later remove the device.
32
System x3100 M3 Type 4253: Installation and User’s Guide