IBM System x iDataPlex dx360 M4 7912, Руководство по обслуживанию

Страница: 311 / 400

2. Read the safety information that begins on page vii and “Installation guidelines”
on page 275.
3. Turn off the server and peripheral devices and disconnect all power cords;
then, remove the cover (see “Removing the system-board tray cover” on page
280).
4. Remove the system battery (see “Removing the system battery” on page 290)
if you have not done so.
5. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
c. If you removed a rubber cover from the battery holder, use your fingers to
install the battery cover on top of the battery connector.
6. If you removed the PCIe riser-card assembly, install it (see “Installing a PCI
riser-card assembly on the system-board tray” on page 303).
7. Install the system-board tray cover (see “Installing the system-board tray
cover” on page 280).
8. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 279).
9. Reconnect the external cables; then, reconnect the power cords and turn on
the peripheral devices and the server.
10. Start the Setup utility and reset the configuration.
v Set the system date and time.
v
Set the power-on password.
v Reconfigure the server.
See “Using the Setup utility” on page 345 for details.
Removing a simple-swap hard disk drive
You must turn off the server before removing simple-swap drives from the server. To
remove a simple-swap hard disk drive or solid-state drive, complete the following
steps.
Chapter 5. Removing and replacing server components
293