IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 196 / 264

Removing a storage enclosure
To remove a storage enclosure, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 123.
2. If the storage enclosure is installed on a system-board tray, remove it (see
“Removing an expansion enclosure from a system-board tray” on page 131).
3. Carefully set the storage enclosure on a flat, static-protective surface.
4. Make a note of where the hard disk drives are installed; then, remove them.
Place them on a static-protective surface or install them in the new storage
enclosure (see “Removing and installing a hard disk drive” on page 139).
5. Note the cable routing; then, remove the hard disk drive bracket and cable
assembly (see “Removing and installing a one-bay or four-bay hard disk drive
bracket and cable assembly” on page 168).
6. If you are instructed to return the storage enclosure, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
180
System x iDataPlex dx360 M2: Problem Determination and Service Guide