IBM System Storage TS7600 ProtecTIER Series, Руководство по обновлению программного обеспечения

Страница: 22 / 132

Table 2. Responding to the microcode version (continued)
If the current TSSC code
level is...
And if you are... Do the following...
5.9.x A customer or an IBM
Service Representative Skip the remainder of this
chapter and go on to
“Upgrading stand-alone
servers to ProtecTIER
v3.1.x.x” on page 14 or
Chapter 4, “Installing and
configuring the ProtecTIER
v3.1.x.x upgrade,” on page
11, as applicable.
Re-imaging the TSSC microcode
About this task
IBM Service Task
Procedure
1. Carefully review the information below and then proceed to step 2.
Attention:
v
Rebuilding the hard disk drive will permanently destroy any local data
present on the drive.
Using the System Console Product Recovery CD will
return the console to its "as shipped" state.
v
After performing the procedure below, you will need to reload any
application(s) specific to the products displayed in the Attached Systems
list, such as TS7650, TS7740, or attached control units.
For example, you
might have to reload the Storage Manager GUIs, ProtecTIER Manager GUI,
and Information Centers for TS7650. The actual applications depend on the
systems that are attached to the TSSC. Refer to the
IBM System Storage
TS3000 System Console (TSSC) Maintenance Information for additional
information.
v
Do not load or attempt to use the System Console Product Recovery CD
on any machine type other than 6579, 6792, 8480, 8482, 8485, 8836, or 8849.
If you use the System Console Product Recovery CD on any other machine
type, the installation fails and that machine is unusable.
v Do not attempt to restore configuration settings from a v1.x.x console
onto a v3.x.x or higher console.
The files are incompatible. Version 2.x.x
files are compatible with v3.x.x or higher.
2. Back up the TSSC console configuration.
Refer to the related topics in the
IBM System Storage TS3000 System Console
(TSSC) Maintenance Information (on the IBM System Storage TS7650 with
ProtecTIER Publications CD) for detailed instructions for backing up and
restoring configuration data.
3. Insert the System Console Product Recovery CD into the TSSC CD-ROM
drive and press <enter> .
4. If you are currently logged into the TSSC, right-click on the TSSC blue
desktop.
The
IBM TS3000 System Console menu displays.
5. Select Logout , then click OK .
You are returned to the login screen.
8
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide