IBM System Storage TS2900, Руководство по установке, эксплуатации и обслуживанию

Страница: 57 / 257

Chapter 3. Installation and Configuration
3-13
Attaching the Library to a Server
The drive is attached to a server using the Serial Attached SCSI (SAS) interface and
the Web User Interface accesses the library using an Ethernet interface.
Connecting the Host Interface Cables
To connect the host interface cable to the library:
1. It is recommended that you shut down and turn OFF the associated server. Turn
OFF all attached devices. Remove the power cords from the server and all
attached accessories.
Figure 3-15. Interface cable connection
Important: Failure to remove the power cords from these devices before
connecting the host interface cable could result in damage to the
library.
1. Attach an Ethernet cable to the Ethernet port ( in Figure 3-15).
Note: On rack mount installations, run the cable through the hook and loop fastener
strap on the right rear bracket.
2. Attach the host end of the SAS cable to the drive’s SAS connector ( in
Figure 3-15).
Note: On rack mount installations, run the cable through the hook and loop fastener
strap on the right rear bracket.
3. Attach the other end of the host SAS interface cable to the host or to an interposer
if required.
4. Method 1 : Plug the Ethernet cable into your server or PC to access the Web User
Interface directly. This method allows you to modify your server or PC network
settings to match the library default settings, or use the library Operator Panel to
change the library network settings to match the server or PC network settings
a
29z0100
1 2 3
1
2