IBM System Storage TS2240, Руководство по установке, эксплуатации и обслуживанию

Страница: 110 / 141

7. Test the drive (see “Function Code 1: Run Drive Diagnostics” on page 3-10) to
determine if it should be replaced.
No Apparent Failure or Damage to Tape
1. Set the drive on its left side with the head and tape path facing up.
1
Loader motor worm gear
3
Takeup reel motor
2
Outer guide rail
WARNING: DO NOT
TOUCH
4
Supply reel motor
2. Begin spooling the tape back into the cartridge by turning the supply reel motor
(
4
in Figure E-11) clockwise.
3. Continue spooling into the cartridge until the tape is taut and remains within
the flanges of the tape guiding rollers. Ensure that you do not stretch the tape.
Continue spooling until all tape is removed from the takeup reel (
3
in
Figure E-11).
4. Locate the threader intermediate gear (
1
in Figure E-12 on page E-13) near
the rear of the drive. You can use your finger to rotate the threader
intermediate gear (
1
in Figure E-12 on page E-13) and slowly rotate the
threader mechanism gear (
2
in Figure E-12 on page E-13) clockwise.
This draws the tape leader block assembly (LBA) into the cartridge.
3
4
1
2
a82hd002
Figure E-11. Rewinding tape into cartridge
E-12
TS2240 Tape Drive Setup, Operator and Service Manual