IBM Storwize V7000, Руководство по обслуживанию

Страница: 75 / 172

time_to_charge
field for the battery. The results provide an estimate of the
time, in minutes, before the system can start. If the time is not 0, wait for the
required time. Check that the node canister that you inserted the USB key into
has its clustered-state LED on permanently. For additional information, see
“Procedure: Understanding the system status using the LEDs” on page 49.
10. If the initialization was successful and the batteries are sufficiently charged,
point a supported browser to the management IP address that you specified
to start the management GUI. You see the management GUI logon panel.
11. Log on as superuser. Use passw0rd for the password.
12. Follow the on-screen instructions.
For more information about using the USB key, see “USB key and Initialization
tool interface” on page 33.
Procedure: Initializing a clustered system using the service assistant
Use this procedure to initialize a clustered system using the service assistant rather
than the USB key.
Note: The service assistant gives you the option to create a clustered system only
if the node state is candidate.
To initialize a clustered system using the service assistant, perform the following
steps:
1.
Point your web browser to the service address of the upper node canister in
your control enclosure: 192.168.70.121 subnet mask: 255.255.255.0.
2. Log on with the superuser password. The default password is
passw0rd
.
If you are unable to connect, see “Problem: Cannot connect to the service
assistant” on page 43.
If the default service assistant address cannot be used in your network
environment, connect using a direct Ethernet connection. To make this
connection, see “Procedure: Accessing a canister using a directly attached
Ethernet cable.”
3. Select Manage System .
4.
Enter the system name and the management IP address.
5. Click Create System .
Attention: Without a USB key to service the system, it is not possible to reset the
superuser password or to change the service IP addresses in the event of a fault
that prevents access to the management interface. It is essential that you take steps
to record this information for use in the event of a failure.
Procedure: Accessing a canister using a directly attached Ethernet
cable
Use this procedure if you need to use a direct Ethernet connection to attach a
personal computer to a node canister to run the service assistant or to use the
service CLI.
Perform this procedure if you are not authorized to use a USB key in your data
center and when the service address of your nodes cannot be accessed over your
Ethernet network. This situation might occur for a new installation where the
Chapter 6. Resolving a problem
59
|
|
|
|
|