IBM Storwize V5000, Быстрое руководство по установке

Страница: 49 / 80

Connecting a control enclosure to a host
When you install a control enclosure, you can connect it to a host with SAS cables.
You can use onboard host SAS ports on some models or an optional SAS host
interface adapter. Note that onboard SAS host ports are not available on all system
models.
About this task
Two types of SAS cables are used for host attachment, depending on the
requirements of the host.
v Mini SAS HD to Mini SAS HD (Figure 21)
v
Mini SAS HD to Mini SAS (Figure 22)
Note: When you insert a SAS cable, make sure that the connector is oriented
correctly.
v When you connect cables to the SAS ports on the left side of the node canister,
the blue pull tab must be below the connector.
v Insert the connector gently until it clicks into place. If you feel resistance, the
connector is probably oriented the wrong way. Do not force it.
v When inserted correctly, the connector can only be removed by pulling the tab.
v3500179
Figure 21. Mini SAS HD to Mini SAS HD cable
ite00052
Figure 22. Mini SAS HD to Mini SAS cable
Chapter 2. Installing the hardware
25