IBM Storwize V5000 Gen2, Быстрое руководство по установке

Страница: 131 / 178

Figure 109. Installing the display panel assembly
3. Insert the display panel assembly until it clicks into position.
4. Replace the top cover, as described in “Installing or replacing the top cover: 2077-92F ” on page 58.
5. Ensure the LEDs on the display panel are lit correctly. See “ Storwize V5000 2077-92F expansion
enclosure LEDs and indicators” on page 112 for details.
Removing the support rails: 2077-92F
You can remove the support rails for the 2077-92F expansion enclosure.
About this task
This task assumes the following conditions:
• The cable management arm is removed, as described in “Removing or moving the cable-management
arm: 2077-92F or 2078-92F ” on page 50.
• The expansion enclosure is removed from the rack, as described in “Removing an expansion enclosure
from a rack: 2077-92F ” on page 79.
Procedure
1. Remove the two screws that attach the outer rail section to the front bracket assembly, as shown in
Figure 110 on page 105.
Figure 110. Remove the rail assembly from the front frame bracket
2. Remove the rail section by pulling it away from the front bracket, as shown in Figure 110 on page 105.
3. Remove the two screws that attach the inner rail section to the rear bracket, as shown in Figure 111 on
page 105.
Figure 111. Remove the rail assembly from the rear frame bracket
Chapter 2. Installing the system hardware 105