IBM SR9 AGP 4X DVI-I IBM, Дополнение к руководству пользователя

Страница: 15 / 28

Installing the SR9 AGP 4X DVI-I Graphics
Adapter
To install the SR9 AGP 4X DVI-I Graphics Adapter:
1. Turn off all attached devices; then turn off your computer. Unplug the power
cords of all attached devices and your computer. Remove the cover from your
computer. For instructions on how to remove your computer’s cover, refer to the
documentation that comes with your computer.
For IBM computers, refer to About Installing Options for instructions on opening
the computer cover, removing existing adapter cards, and installing adapter cards
in expansion slots.
2. Remove any previously installed graphics adapter cards. If you have no other
graphics adapter cards, but your computer system board has built-in VGA
graphics capability, make sure the VGA graphics capability is disabled. For
information on disabling the VGA graphics capability on your computer, see the
documentation that comes with your computer.
3. Choose an AGP expansion slot.
Note: Inserting a graphics adapter into the wrong type of slot might damage
your adapter, your computer, or both.
To identify the location of each type of expansion slot in your computer, refer to
the documentation that comes with your computer.
Note: Do not insert the plastic tab next to the connector pins into the expansion
slot.
4. Remove the expansion slot cover for the expansion slot you intend to use. Save
the screw to use with the mounting bracket.
5. Position the graphics adapter over the expansion slot you have chosen. Push the
graphics adapter in firmly and evenly until it is fully seated in the slot.
Part 1: Installation Guide 1-9