IBM SAN768B-2, Руководство пользователя

Страница: 64 / 228

The initial physical hardware installation continues with the following steps:
v
“Providing power to the SAN768B-2” on page 37
v
“Establishing a serial connection and logging on to the SAN768B-2” on page 37
v
“Configuring the IP addresses” on page 38
v
Installing optical transceivers and cables (see “Removing and installing
transceivers” on page 108 and “Managing cables” on page 46)
The following additional steps are customer responsibilities, generally completed
during the initial configuration:
1. Establish an Ethernet connection. See “Establishing an Ethernet connection” on
page 40.
2. Specify a switch name. See “Customize a switch name” on page 40.
3. Specify a domain ID for the SAN768B-2. See “Setting the Domain ID” on page
41.
4.
Set the date and time. See “Setting the date and time” on page 41.
5. Verify the PID mode and connect the SAN768B-2 to the fabric. See “Verifying
the persistent PID feature” on page 43.
6. Enable software licenses. See “Determining installed software licenses” on page
43.
Configuration Tasks
Connect Serial Cable
between Switch and Host
Log In to Serial Console Port
Set IP Address
Log off Serial Console Port
and Disconnect Serial Cable
Connect Ethernet Cable
and Open Telnet Session
Set Domain ID
Set Date and Time
Install SFPs and
Attach Cables
Manage Cables
Verify Operation and
Back Up Configuration
384b004
Figure 13. Flow of basic configuration tasks
36
SAN768B-2 Installation, Service, and User Guide