Figure 5. Attaching the front brackets
1 - The SAN64B-6 switch
2 - Front brackets
3 - Screws, 8-32 x 5/16-in., flathead Phillips
Attaching the extension brackets to the device
About this task
Perform the following steps to attach the extension brackets to the device. You can use medium and long
extension brackets for this task.
Procedure
1. Select the proper length extension bracket for your rack depth.
2. Position the right extension bracket along the side of the device as shown in Figure 6 on page 16.
3. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the extension
bracket and then into the holes on the side of the device. Use the upper and lower screw holes, leaving
the center holes empty.
4. Repeat step “2” on page 15 and step “3” on page 15 to attach the left extension bracket to the left
side of the device.
5. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
Chapter 3. Mounting the switch 15
Содержание SAN64B-6
