IBM SAN42B-R, Инструкция по установке, обслуживанию и эксплуатации

Страница: 67 / 96

CAUTION:
Be careful not to insert your fingers into the fan while removing it from the
device. The fan may still be spinning at high speed.
CAUTION:
Hazardous moving parts nearby. (L008)
2. Remove the fan from the chassis by using the handle (
2
) on the fan to pull it
straight out and away from the chassis.
3. Install the new fan in the chassis:
a. Orient the new fan with the captive screw
3
on the right, as shown in
Figure 24.
b. Gently push the fan into the chassis until it is firmly seated.
Attention: Do not force the installation. If the fan does not slide in easily,
ensure that it is correctly oriented before continuing.
c.
Using the Phillips screwdriver, secure the fan to the chassis by tightening
the captive screw
3
.
4. Verify that the fan status LED is steady green to indicate normal operation
(refer to Table 7 on page 36). If the LED is not steady green, ensure that the fan
is securely installed and seated properly.
5. Optionally, use the command line interface (CLI) to enter the
fanShow
command
to display the status. You can also use the
chassisShow
command. The fan
status can also be viewed using the Web Tools application.
Chassis replacement
The SAN42B-R chassis is highly reliable and unlikely to fail. However, the chassis
is available as a FRU and can be replaced following these instructions.
b965030
Figure 24. Removing and replacing a fan in the switch
Chapter 4. FRU replacement
43