IBM SAN42B-R, Инструкция по установке, обслуживанию и эксплуатации

Страница: 36 / 96

7
- Screw, 6-32 x 1/4-in., panhead Phillips (8)
8
- Screw, 10-32 x 5/8-in., panhead Phillips (8)
9
- Retainer nut, 10-32 (8)
Installation instructions for flush-front mounting
To install the switch in a cabinet with the switch mounted flush with the front of
the rack, use the following instructions.
Attention: The switch must be turned off and disconnected from the fabric
during this procedure.
Note:
The illustrations depict a 1U switch. The procedures and positioning are the
same for the 2U high SAN42B-R.
Attaching the front brackets
Complete the following steps to attach the front brackets to the switch. See
Figure 5 on page 11 for detailed illustrations of the parts.
1. Position the right front bracket (
2
) with the flat side against the right side of
the switch at the front of the switch, as shown in Figure 6.
1
- Switch
2
- Front brackets (2)
3
- Screw, 8-32 x 5/16-in., flathead Phillips (16)
2. Insert four 8-32 x 5/16-in. flathead screws (
3
) through the vertically aligned
holes in the bracket and then into the holes on the side of the switch. Use the
upper and lower screw holes, leaving the center holes empty.
3. Repeat steps 1-2 to attach the left front bracket to the left side of the switch.
4.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lbs (17 cm-kgs).
2
3
1
3
b42r006
Figure 6. Attaching the front bracket
12
SAN42B-R Installation, Service, and User Guide