IBM SAN32B-E4, Инструкция по установке, обслуживанию и эксплуатации

Страница: 72 / 92

Changing the switch serial number
Attention: This procedure is to be used only if a switch has failed and it is
being replaced by a new switch.
In the event of a hardware failure, the replacement switch should be configured to
display the serial number of the original failed switch, in order to maintain
continuity in the IBM service system. Once you have installed the replacement
switch, follow the steps below to change the serial number displayed through the
switch or fabric management program.
Note:
This serial number change procedure requires the user to login as "root".
1. Login as "root" on the switch.
2.
Enter the root password "
xxxxxxxx
". Press
Enter
.
3. Enter the fruinfoset chassis 1 command. Press Enter .
4.
ID: (none). Press Enter .
5. PN: (none). Press Enter .
6. SN: (none) > type " switch Serial Number ". Press Enter .
7. RV: (none). Press Enter .
8. Chassis SN: (FAxxXxxxxxx). Press Enter .
To verify that the serial number has been entered correctly, follow these
steps:
9. Enter the fruinfoset chassis 1 command. Press Enter .
10.
ID: (none). Press
Enter
.
11. PN: (none). Press Enter .
12.
SN: (none) > Verify that the "switch Serial Number" displayed is the one you
entered. Press
Enter .
13. RV: (none). Press Enter .
14. Chassis SN: (FA0xxXxxxxxx). Press Enter .
If the serial number displayed is not correct, repeat the above steps, beginning
with step 3.
Powering off the switch
To power off the switch:
1. Using the CLI, enter the sysShutDown command.
Note: This command shuts down the key processors and powers off the
switch. All LEDs go dark.
2. Set each AC power switch to “ O ”.
3. If necessary, disconnect both power cords from the switch and the facility
power to remove power from the system.
46
SAN32B-E4 Installation, Service, and User Guide