IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 31 / 292

– Core routing blades use QSFP+ and QSFP28 optical transceivers. For a list of supported transceivers
for these blades, refer to “Supported transceivers and cables” on page 65.
v
Chassis door. This door must be installed to meet EMI compliance certification.
v Two vertical cable management finger assemblies. These install on the equipment rack for cable
management.
Note: Device control processors and management modules contain batteries for RTC/NVRAM backup.
Do not attempt to replace these batteries. Dispose of hardware components containing these batteries as
required by local ordinances and regulations.
Port-side view of device
The following illustration shows the port-side view of the SAN256B-6 Director with installed blades
identified. Note that an SX6 extension blades are not shown in the following illustration, but would
install in the same slots as the FC32-48 or FC32-64 port blades. A maximum of four SX6 blades are
supported.
1. Front air vent
2. Control processor blades (CPX6) – slot 1 (left), slot 2 (right)
3. Port blades (FC32-48)
4. Core routing blades (CR32-4)
5. Side air vent
Note:
When nonport-side exhaust (NPE) fan and power supply assemblies are installed, air flows
through the side vent and exhausts to the nonport side. When nonport-side intake (NPI) fan and power
Figure 1. Port side of the SAN256B-6 Director (sample configuration)
Introducing the SAN256B-6
3
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|