IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 157 / 292

SAN256B-6, SAN512B-6, SAN384B-2 and SAN768B-2 Directors can also be connected in a full-mesh
configuration.
For details on the following subjects, refer to the "Inter-Chassis Links' section of the Fabric OS
Administration Guide:
v ICL topologies
v ICL trunking
v Configuring ICLs between SAN256B-6 or SAN512B-6 Directors
v Configuring ICLs between SAN256B-6, SAN512B-6, SAN384B-2 and SAN768B-2 Director models
Precautions specific to the blade
This document describes how to remove and replace a core routing blade.
Observe the following precautions when replacing these blades:
v The CR32-4 core routing blade is compatible only with the SAN256B-6 .
v Wear an appropriately grounded ESD wrist strap when handling and installing blades and cards.
Follow electrostatic discharge (ESD) precautions. Wear a wrist grounding strap connected to chassis
ground (if the chassis is plugged in) or a bench ground.
v Install core routing blades only in slots 5-6. These blades cannot be installed in other slots as guide
pins and connectors in each slot allow only specific blade types.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
Figure 58. IBM SAN Director core-edge ICL topology
Core Routing Blades
129
|
|
|
|
|
|
|
|
|
|
|