IBM SAN192C-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 85 / 160

1. Vertical mounting rails on the rack.
2. Mounting brackets for two post racks
3. Six M6 x 19 mm or 10-24 x 3/4 in. Phillips screws used to attach each
side bracket to a front mounting rail (use a total of 12 screws)
4. Eight M6 x 10 mm screws used to attach each bottom support rail to the
chassis (use a total of 16 screws for both rails)
8. Use eight M6 x 10 mm screws to attach the bottom-support rails to the chassis
(use a total of 16 screws for both bottom support rails). See Figure 30.
9. If you removed any fabric modules before moving the chassis, replace each
one in the chassis as follows:
a.
Holding the front of the fabric module (the side with the LEDs), turn the
module so that the front side is vertical.
Note: The top of the module has an alignment bracket running from the
rear to the front. The electrical connectors will be at the bottom.
b. Align the rear of the fabric module to an open fabric slot and insert the
bracket on top of the module into the track at the top of the slot.
Note: If there are only three fabric modules to install, install them in fabric
slots 1, 3, and 5, and be sure that there are blank filler plates installed in
the open slots.
c. Slide the module part way into the slot.
d.
Press the ejector button on the front of the module, to release the levers
from the front of the module.
e. Rotate the levers away from the front of the module and hold them while
sliding the module all the way into the slot.
f. Simultaneously rotate both levers to the front of the module. They click
when locked to the front of the module.
Figure 30. Attaching the Chassis to the Rack
Chapter 3. Installing the IBM c-type SAN Device
61