IBM SAN192C-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 139 / 160

Table 43. 10/100/1000BASE-T Management Port Cable Pinout (MDI) (continued)
Pin Signal
8 Not used
Figure 41 shows a schematic of the 10/100/1000BASE-T cable required to connect
the management port to a switch or hub (not provided with the switch).
Supported Power Cords and Plugs
Each power supply has a separate power cord. Standard power cords or jumper
power cords are available for connection to a power distribution unit having IEC
60320 C19 outlet receptacles.
Power Cords
The standard power cords have an IEC C19 connector on the end that plugs into
the switch. The optional jumper power cords have an IEC C19 connector on the
end that plugs into the switch, and an IEC C20 connector on the end that plugs
into an IEC C19 outlet receptacle.
Note: Only the regular power cords or jumper power cords provided with the
switch are supported.
Note: If you do not order the optional power cord with the system, you are
responsible for selecting the appropriate power cord for the product. Using a
non-compatible power cord with this product can result in electrical safety hazard.
Orders delivered to Argentina, Brazil, and Japan must have the appropriate power
cord ordered with the system.
Table 44 lists the power cords for the IBM c-type Directors and provides their
lengths in feet and meters.
Table 44. Power Cords for the IBM c-type Director
Description Length
Feet Meters
SAN384C-6 - 3000W Power Supply
Power Cord, 250VAC 20A NEMA, 6-20 Plug, USA 13.12 4
Figure 41. Twisted-Pair 10/100/1000BASE-T Cable Schematic
Appendix B. Cable and Port Specifications
115