IBM SAN Volume Controller 2145, Быстрый старт

Страница: 36 / 46

Figure 3. Opening the hinge brackets
5. Align the holes in the rail bracket with the holes on the front and rear rack cabinet flanges.
Ensure that the rails are aligned on the inside of the rack cabinet.
6. On the rear of the rail, press the two bracket pins into the holes in the rack flanges.
7. Close the rear hinge bracket to secure the rail to the rack cabinet flange.
(See Figure 4 on page 16.)
Figure 4. Closing the hinge brackets
8. On the front of the rail, press the two bracket pins into the holes in the rack flanges.
9. Close the front hinge bracket to secure the rail to the rack cabinet flange.
(See Figure 4 on page 16.)
10. Secure the rear of the rail to the rear rack flange with two black M5 screws.
11. Repeat the steps to secure the opposite rail to the rack cabinet.
12. Repeat the procedure to install rails for each additional control enclosure.
16 SAN Volume Controller 8.3.1: Machine Types 2145, 2147 Models SA2, SV2