IBM SAN Volume Controller 2145-CF8, Руководство по установке оборудования

Страница: 79 / 101

Flashing
The SAN Volume Controller is turned off but is still connected to a
power source.
Location LED
The SAN Volume Controller does not use this LED, which is the middle of
the three LEDs.
System-error LED
This LED is the rightmost of the three LEDs. The LED indicates that a
system board error has occurred. Light path diagnostics provide more
information about the error.
Ethernet-link LED
The Ethernet-link LED indicates that there is an active connection on the Ethernet
port.
An Ethernet-link LED is located beside each Ethernet port.
Ethernet-activity LED
An Ethernet-activity LED beside each Ethernet port indicates that the SAN Volume
Controller 2145-CF8 is communicating on the Ethernet network that is connected to
the Ethernet port.
SAN Volume Controller 2145-CF8 connectors
External connectors that the SAN Volume Controller 2145-CF8 uses include four
fibre-channel ports, a serial port, two Ethernet ports, and two power connectors.
Figure 43 shows the external connectors on the SAN Volume Controller 2145-CF8
back panel assembly.
1
Fibre-channel port 1
2
Fibre-channel port 2
3
Fibre-channel port 3
4
Fibre-channel port 4
5
Power-cord connector for power supply 1
6
Power-cord connector for power supply 2
7
Serial connection for UPS communication cable
8
Ethernet port 2
9
Ethernet port 1
Figure 44 on page 54 shows the type of connector that is located on each
power-supply assembly. Use these connectors to connect the SAN Volume
Controller 2145-CF8 to the two power cables from the uninterruptible power
4 3 1 2 6 5
7
9
svc_00219_cf8
8
Figure 43. Connectors on the rear of the SAN Volume Controller 2145-CF8
Appendix C. SAN Volume Controller hardware controls, indicators, and connectors
53