QuickOn for Windows for the IBM Network Station Release 3.0
Page 4 of 13
http://publib.boulder.ibm.com/pubs/pdfs/redbooks/sg245212.pdf.
l
Flash Memory Card Support for the IBM Network Station Release 3.0
.
Access this information on the web at the following URL:
http://www5.pc.ibm.com/us/me.nsf/TeInformation%5cStation.
2. Setup
Introduction
This section explains how to use the flash card to boot the Network Station with ICA.
Network Station Setup
You only need to perform the instructions below once for each Network Station. After you configure
the system, the Network Station NVRAM saves the configuration parameters for future use.
Network Configuration Information
You need the following information in order to boot a Network Station with QuickOn for Running
Windows:
l
The IP address of the Network Station.
l
The IP address of the MetaFrame, WinFrame, or WinCenter server.
l
The subnet mask, gateway, and other network setup parameters.
Boot Monitor
If the Network Station boot monitor is below V3.0.7.3, the QuickOn for Running Windows flash card
automatically updates the boot monitor to V3.0.7.3.
Installing the Flash Card
Before you power on the Network Station, insert the QuickOn for Running Windows flash card into
the PC Card drive. Do not insert the flash card when the Network Station is powered on.
Clearing NVRAM
You need to clear NVRAM the first time that you boot from the QuickOn for Windows flash card.
This clears any residual setting in the Network Station NVRAM.
1. Power off your Network Station.
2. Power on your Network Station.
3. Press the
Esc
key when you see the
Search for Host System...
message. You will now be
on the Setup Utility screen.
4. Use
<LeftCtrl>-<LeftAlt>-<LeftShift>-F1
to enter the Boot Monitor. The Boot Monitor
responds with
