IBM QS22 - BladeCenter - 0793, Инструкция по установке и эксплуатации

Страница: 40 / 114

Complete the following steps to remove the front bezel assembly:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 19.
2. If applicable, shut down the operating system, turn off the blade server, and
remove the blade server from the BladeCenter unit. See “Removing the blade
server from the BladeCenter unit” on page 20.
3. Open the blade server cover. See “Opening and removing the blade server
cover” on page 21.
4. Carefully disconnect the control panel cable from the control panel connector
(see Figure 11).
5. Press the front bezel release on both sides of the system board and pull the
front bezel assembly away from the blade server.
6. Store the front bezel assembly in a safe place.
Installing the optional modular flash drive
The modular flash drive connects to the flash drive connector on the system board
and provides non-volatile memory. This may be used, for example, for installing an
operating system.
Complete the following steps to install the modular flash drive:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 19.
2. If applicable, shut down the operating system, turn off the blade server, and
remove the blade server from the BladeCenter unit. See “Removing the blade
server from the BladeCenter unit” on page 20.
3. Open the blade server cover. See “Opening and removing the blade server
cover” on page 21.
Control-Panel
Cable
Bezel release
Bezel assembly
Blade cover
Control-Panel
Connector
Cover release
Cover release
Bezel release
Figure 11. Removing the front bezel assembly
24
BladeCenter QS22 Type 0793: Installation and User’s Guide