IBM PowerLinux 7R2, Установка

Страница: 37 / 58

Reference information
Use this information to learn more about the tasks associated with a system installation.
Installing rack-mounted and factory-racked servers
Use this information to learn about installing rack-mounted and factory-racked servers.
Note: The screws included in the shipment are used to secure the drawer to the rack. Use these screws if
you are moving the rack and drawer to another location, or if you are in an area prone to vibrations or
earthquakes.
Installing the rack-mounted server
Use this information to learn about installing a rack-mounted server.
To install a rack-mounted server, complete the following high-level tasks:
Table 3. Tasks to install the server into a rack
Task Where to find associated information
Check the prerequisites. For instructions, see “Prerequisites for installing the
8246-L2D or 8246-L2T system” on page 1.
Perform the inventory. For instructions, see “Before you begin” on page 1.
Verify that you have a rack. You must first have a rack installed. If you do not have a
rack installed, see Installing the rack
(http://publib.boulder.ibm.com/infocenter/systems/
scope/hw/topic/p7hbfl/installrack.htm).
Determine where you want to install the rails and mark
the location. To determine and mark the location, see “Determining
the location” on page 3 and “Marking the location” on
page 4.
Attach the mounting hardware to the rack. To install the mounting hardware to the rack, see
“Attaching the 8246-L2D or 8246-L2T mounting
hardware to the rack” on page 5.
Install the system into the rack. To install the system into the rack, see “Installing the
8246-L2D or 8246-L2T system into the rack” on page 8.
Install the cable-management arm. To install the cable-management arm, see “Installing the
cable-management arm” on page 9.
© Copyright IBM Corp. 2013
25