IBM Power System 5802, Инструкция по эксплуатации

Страница: 15 / 64

Installing the 5802 and 5877 expansion units: Details
The detailed installation procedure includes information from online references that are specified in the
overview. You can use the expanded instructions in this procedure to install your expansion unit into a
rack and to cable it to a server.
v
This information is provided in printed form as list of basic tasks for installing the 5802 and 5877
expansion units. For the most current version, use the online information: Installing the 5802 and 5877
expansion units (http://publib.boulder.ibm.com/infocenter/systems/scope/hw/topic/p7ecy/
p7ecy.pdf).
v
To ensure that server firmware has been updated to a level that supports this expansion unit, see the
IBM Prerequisite (https://www-912.ibm.com/e_dir/eserverprereq.nsf).
v
This procedure supports the following installation scenarios:
– Your 5802 or 5877 expansion unit was delivered already mounted in a rack, and you must complete
the installation.
– Your 5802 or 5877 expansion unit was delivered separately from a rack, and you must mount the
enclosure in an existing rack and complete the installation.
Note: If the rack is not yet installed, you must first complete the procedure for Installing the rack
(http://publib.boulder.ibm.com/infocenter/systems/scope/hw/topic/p7hbf/installrack.htm).
v
Before you install the expansion unit into a rack, read the Rack safety notices (http://
publib.boulder.ibm.com/infocenter/systems/scope/hw/topic/p7hbf/racksafety.htm).
To install the 5802 or 5877 expansion unit, complete the following tasks:
1.
Choose the type of installation you are completing:
v
To complete the installation of a 5802 or 5877 expansion unit that was delivered already mounted in
a rack, go to step 2.
v
To complete the installation of a 5802 or 5877 expansion unit that was delivered separately from a
rack, go to step 4 on page 4.
2. Remove the bracing bracket that is attached at the rear of the expansion unit as follows:
a. Loosen the captive thumbscrew on the retention bracket (B) that secures the shipping bracket (A)
to the 5802 or 5877 expansion unit. Remove the retention bracket.
© Copyright IBM Corp. 2010, 2013
3