IBM Power 730 Express 8231-E2B, Руководство пользователя

Страница: 28 / 112

Attention:
Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic discharge
from damaging your hardware.
When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It
does not increase or decrease your risk of receiving electric shock when using or working on electrical
equipment.
If you do not have a wrist strap, prior to removing the product from ESD packaging and installing or
replacing hardware, touch an unpainted metal surface of the system for a minimum of 5 seconds.
1. Replace the system backplane.
Note: Use care when you replace the system backplane.
a. Carefully grasp the replacement system backplane by both of the heat sink load arms (A). See
Figure 13 or Figure 14 on page 17.
b.
Lower the system backplane at an angle, biased toward the front of the system chassis.
c. Lower the rear of the system backplane (1), and then slide it toward the rear of the system until
the connectors clear the openings in the chassis.
d. Lower the front of the system backplane (2) onto the alignment pins (B).
Figure 13. Replacing the system backplane in the 8231-E2B
16
Power Systems: System backplane for the 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C, 8231-E2D, or 8268-E1D