IBM Power 720 Express 8202-E4B, Руководство пользователя

Страница: 98 / 228

5. Hold the disk drive or solid-state drive by the top and bottom edges as you position the drive, and
insert it into the system or the expansion unit. Do not hold the disk drive or solid-state drive by the
handle.
6.
Slide the disk drive or solid-state drive all the way into the system or an expansion unit, and push
the drive handle
(A) in until it locks, as shown in Figure 53.
Note: It is important to ensure that when installing a drive, that the drive is fully seated and all the
way into the system.
Proceed to the procedure for completing the drive replacement. For instructions, see “Completing the
procedure” on page 84.
Replacing a solid-state drive in the 5888 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the 5888 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note: Do not hold the solid-state drive only by the handle. Support the drive by holding the drive by
its sides.
2. Slide the solid-state drive into the 5888 PCIe storage enclosure until the drive stops.
3. Rotate the handle (A) to the locked position, as shown in Figure 54 on page 83.
4. Install the bezel (B) .
Figure 53. Replacing a disk drive or solid-state drive in the system
82
Disk drives or solid-state drives