5
Connection Status Indicators
IBM PCI WAN MultiPort T1/E1 S94 and
IBM PCI WAN MultiPort T1/E1 P92
The green LED adjacent to each port on the IBM PCI
WAN MultiPort T1/E1 S94 and the IBM PCI WAN
MultiPort T1/E1 P92 (see Figure 2 at right) provides a
convenient indication of the status of the connection on
that port.
Explanations for the different LED states can be found
in Table 1 below.
LED State
Connection Status
Remedy
Off
The port is not loaded (the configuration
file describing protocol and interface
parameters has not been read by the
device driver on the PC).
Consult your networking software
for instructions on how to load a
configuration file and how to start a
connection.
Rapid Flash
(stays on for
1/2 second)
The connection has not been established.
Either the port is loading, OR there is no
response from the destination device,
OR the WAN Adapter is waiting for a
VHSI cable to be connected to the port.
Verify that the cable is properly
connected to the port. If the light
continues flashing after a few
minutes, verify that the destination
device is active.
Slow Flash
(stays on for
1 second)
The connection was interrupted
unexpectedly. The cable was unplugged
or damaged while a connection was
active.
Reconnect the cable.
On
The port is active and the connection
is good.
Table 1: LED States
Figure 2: End Bracket
Port 1
LED 1
Port 2
LED 2
