IBM Nways 8260, Руководство по установке

Страница: 7 / 25

4. Check that you can PING the TFTP server from the 8260 LEC.
ww
Serial Line IP support (SLIP) mode.Make sure your workstation can act as a TFTP
server .
1. Set up a A-CPSW Configuration Console in SLIP Mode:
2. Then configuring the SLIP interface on the TFTP workstation will allow you to perform Inband
Download between your workstation and the A-CPSW.
3. The SLIP connection will be broken after a reset of the A-CPSW and connection will be
operational in normal mode.
1.4 Out of Band Download method
Ÿ
FPGA picocode cannot be downloaded using this method, only boot and operational.
Ÿ
Download can only be performed on active CPSW.
Once you have the code on your A-disk or hard disk, and you have connected your PC on the
RS232 port, using an RS232 emulated terminal, you have to type the following commands on
the command line:
MAINTAIN
DOWNLOAD OUT-OF-BAND BOOT (or OPERATIONAL)
You then have to choose the Xmodem protocol and select the path where your code is
located.
Note: This method is not recommended since it takes more time than the In-Band
method.
Ž
Installation Instructions
Copyright IBM Corp. 1998
Page 7
June 17 1998 EC : F34705 PN : 26L0227