IBM Network Printer 12, Быстрая настройка

Страница: 7 / 34

Start Here
This booklet describes how to set up your Network Printer 12. It describes a basic
configuration using a parallel cable connection. This cable needs to be purchased
separately; it is not included with the printer.
Note: In addition to the parallel cable attachment, the Network Printer 12 supports a
wide variety of network attachment interfaces, including serial, twinax, coax, token ring,
and Ethernet attachments. For information about installing network attachments and
other optional features, please read “Installing Other Options and Attachments” on
page 2.
Printer Dimensions
Before you install your printer, make sure you have a place large enough to put it.
Without any of its optional features attached, the printer dimensions are:
Width 16.6 inches (421 mm)
Depth 16.3 inches (415 mm)
Height 9 inches (228 mm)
In addition, make sure you leave enough room around the printer to access and
operate it. IBM recommends leaving at least 18 inches (450 mm) in the back of the
printer, 24 inches (600 mm) in the front of the printer, and 8 inches (200 mm) on each
side.
Standard Features
Standard features of the printer include:
Ÿ Printing speed of up to 12 pages per minute
Ÿ
Resolution of 600 dots per inch (dpi)
Ÿ
PCL5e support
Ÿ
4MB of memory
Ÿ Parallel interface (IEEE 1284)
Ÿ Serial interface (RS-232/422)
Ÿ 250-sheet paper tray
Ÿ 80-sheet auxiliary tray
Ÿ 250-sheet paper output bin
Ÿ Printer drivers

Copyright IBM Corp. 1996
1