IBM NetVista, Техническое руководство

Страница: 17 / 72

Chapter 2. System board features
7
PCI bus
The fully synchronous 32-bit 33 MHz PCI bus originates in the chip set. Features of
these PCI buses are:
• Integrated arbiter with multitransaction, PCI-arbitration, acceleration hooks
• Zero-wait-state, microprocessor-to-PCI write interface for high-performance
graphics
• Built-in PCI bus arbiter with support for all PCI devices and connectors
• Microprocessor-to-PCI memory write posting
• Conversion of back-to-back, sequential, microprocessor-to-PCI memory write to
PCI burst write
• PCI-to-DRAM memory up to 528 megabytes per second (MBps) speed
• PCI 2.2 compliant
• Delayed transaction
• PCI parity checking and generation support
IDE bus master interface
The system board incorporates a PCI-to-IDE interface that complies with the AT
Attachment Interface with Extensions standard.
The bus master for the IDE interface is integrated into the Intel 815E or 810E chip set,
depending on the model. The chip set connects directly to the PCI bus and is
designed to allow concurrent operations on the PCI bus and the IDE bus. The 815E
chip set is capable of supporting PIO mode 0-4 devices and IDE DMA mode 0-5
devices, and ATA 100 transfers of up to 100 Megabytes per second. The 810E chip
set is capable of supporting PIO mode 0-4 devices and IDE DMA mode 0-4 devices,
and ATA 66 transfers of up to 66 Megabytes per second.
The IDE devices receive their power through a four-position power cable containing
+5 v dc, +12 v dc, and ground voltage. When devices are added to the IDE interface,
one device is designated as the master (primary) device and another is designated as
the slave (secondary) device. These designations are determined by jumpers on
each device. Two connectors are provided on the system board for the IDE interface.
One connector is designated Primary, and the other connector is designated
Secondary. Each connector allows two devices to be attached, allowing up to four
devices to be attached to the IDE interface. For information on the connector pin
assignments, see “IDE connectors” on page 33.
For the IDE interface, no resource assignments are given in the system memory or
the direct memory access (DMA) channels. For information on the resource
assignments, see Table 36 on page 49.
USB interface
USB technology is a standard feature of the computer. The A40 and A40p system
boards provide the USB interface with two dual channels integrated into the chip set.
The A20 system board provides the USB interface with one dual channel integrated
into the chip set. A USB-enabled device can attach to a connector, and if that device
is a hub, multiple peripheral devices can attach to the hub and be used by the system.
The USB connectors use Plug and Play technology for installed devices. The speed
of the USB is up to 12 MBps with a maximum of 127 peripheral devices. The USB is
compliant with
Universal Host Controller Interface Guide 1.0 .