IBM NetVista 2289, Руководство пользователя

Страница: 24 / 60

The following illustration shows the locations of parts on the system board.
1
Microprocessor
9
Battery
2
DIMM connector 1
10
Clear CMOS/Recovery jumper
3
DIMM connector 2
11
SCSI LED connector
4
Power connector
12
PCI slots
5
Diskette drive connector
13
Front panel audio connector
6
Primary IDE connector
14
CD-ROM audio connector
7
Front panel connector
15
AGP slot (some models)
8
Secondary IDE connector
16
Serial connector
Installing memory
Your computer has two connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 2.0 GB of system memory.
When installing DIMMs, the following rules apply:
v
Fill each system memory connector sequentially, starting at DIMM connector 1.
v Use 2.5 V, 184-pin, 266MHz double data rate synchronous dynamic random
access memory (DDR SDRAM).
v
Use 128 MB, 256 MB, 512 MB, or 1.0 GB (when available) DIMMs in any
combination.
v
DIMMs are 38.1 mm (1.5 inches) in height.
Note: Only DDR SDRAM DIMMs can be used.
To install a DIMM:
1. Remove the cover. See “Removing the cover” on page 10.
12
User Guide