IBM Netfinity ServeRAID-4H Ultra160, Справочник пользователя

Страница: 124 / 192

Using the IPSSEND command-line program
The IPSSEND command-line program provides a quick way to do the following for
the ServeRAID controller:
v
Backup copies of data (see “FlashCopy function (for Windows NT and Windows
2000 only)”)
v
Copy ServeRAID controller configurations from one server to another (see
“Server roll-out functions” on page 116)
v
Recover from a failed physical drive and rebuild an affected logical drive (see
“Error-recovery functions” on page 118)
v
Isolate problems and debug their cause (see “Problem-isolation and debug
functions” on page 119)
v
Display or modify a limited set of configuration settings (see “RAID Configuration
functions” on page 122).
Note: If you do not have the IPSSEND program installed, refer to “Installing the
IPSSEND and IPSMON command-line programs” on page 53.
When you run IPSSEND with no parameters, a list of available functions and their
specific parameters appears. The available functions and their parameters are
described in the sections that follow.
To run the IPSSEND program with no parameters:
v
If you are using Windows NT 4.0, Windows 2000, or OS/2:
1. Type:
c:
\ipsadm\ipssend
where c is the drive letter of the drive where Windows NT 4.0, Windows
2000, or OS/2 is installed.
2. Press Enter.
v
If you are using NetWare:
1. From the console, type:
load ipssend
2. Press Enter.
v
If you are using Linux, OpenServer, or UnixWare:
1. Type:
/usr/bin/ipssend
2. Press Enter.
v
If you are using DOS:
1. Insert the startable IPSSEND diskette into diskette drive A; then type:
a :\ipssend
where a is the drive letter of the diskette drive.
2. Press Enter.
FlashCopy function (for Windows NT and Windows 2000 only)
FlashCopy creates a quick backup copy of data from a source drive to a target
drive at the instant you issue the command. Any changes made to the source drive
after you issue the command are not reflected on the target drive.
You can use the backup copy for tasks such as tape backup and multiserver rollout
(for example, drive cloning). FlashCopy sets up a link between the source and
110
IBM
®
Netfinity
®
User’s Reference: ServeRAID
™
-4H Ultra160 SCSI Controller